Hydrogen permeability in subsurface

Clean hydrogen is a promising option for reducing carbon dioxide emissions, but it has not yet been used as an energy carrier at the scale required for meeting the net-zero target by 2050. Hydrogen molecules are smaller than nitrogen and methane molecules. Hydrogen, nitrogen, and methane have densities of 0.09 g/L, 1.25 g/L, and 0.71 g/L, respectively, at the standard temperature and pressure. Our knowledge of the geological formations is based on responses to the larger and heavier gases; it is unclear whether we can apply this knowledge to store hydrogen at the required scale.We investigate the single-phase flow of hydrogen in the subsurface and compare it with the single-phase flows of nitrogen and methane. The comparison with nitrogen is helpful because it is used under laboratory conditions. The comparison with methane is also beneficial because engineers understand its behavior under in-situ conditions. We use the Knudsen number (Kn) to determine the flow behaviors under laminar conditions within two domains. The first is a permeable medium representing a conventional gas reservoir, and the second is caprock. Our study shows that the existing knowledge of the first domain's permeability applies to hydrogen flow; however, it is unrealistic for the second domain. The single-phase permeability of the caprock obtained by nitrogen in the laboratory underestimates hydrogen permeability at low pressures (<10 MPa), and the deviation is a non-linear function of pressure. Our study also shows that hydrogen permeability is always larger than methane permeability in the caprock. The difference between the two, controlled by the reservoir pressure, reached 70% in the caprock. The presented results have applications if hydrogen storage in gas reservoirs becomes a reality.     

Design and optimization of ceramic membrane structure: From the perspective of flux matching between support and membrane

The support flux was first investigated as a separate influencing factor for its effect on performances of ceramic filtration membranes. Three pre-membranes were prepared by tape-casting and then transfer-coated to supports to form dual-layer ceramic membranes after sintering. Experiments demonstrated that membrane layers with almost the same properties were obtained despite the huge difference in support flux. When the support flux increases from 3.120 to 97.53 m³m^?2h^?1, the flux of these three membrane series have increased by 75%, 186% and 228%, respectively. Experimental rules can provide structural design and evaluation from the perspective of permeability. The limit membrane flux of a certain system was derived according to the resistance distribution law of internal membrane structure and the Darcy's theorem. On this basis, a method for designing support flux was proposed. Furthermore, we present a criterion to quickly and easily evaluate the match between the support and the top layer, which is the ratio of membrane resistance to total resistance. Finally, the filtration resistance of penetration caused by suction of membrane particles into the support was measured for the first time, taking the advantage of the transfer-coating method that inherently free of penetration. Our works are expected to deepen the understanding of the ceramic membrane structure and provided guidance for its rational design and optimization.     

Microwave absorption properties of CoGd substituted ZnFe2O4 ferrites synthesized by co-precipitation technique

A series of co-precipitated Zn_1?xCo_xGd_yFe_2?yO₄ spinel ferrites (x = 0.0–0.5, y = 0.00–0.10) sintered at 1000 °C were characterized by X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), vibrating sample magnetometery (VSM) and microwave cavity perturbation (MCP). XRD patterns and FTIR spectra reveal formation of the spinel phase along with few traces of GdFeO₃ second phase. The lattice constant decreases with an increasing amount of CoGd ions due to the segregation of Gd³⁺on the grain boundaries and due to replacement of lager Zn²⁺ ions with smaller Co²⁺ ions. SEM shows grain size to decrease with the increase of CoGd contents due to grain growth inhibition by the second phase. VSM results show remanence and saturation magnetization to exhibit an increasing trend due to Co substitution on octahedral sites and presence of a second phase. The coercivity increases with the increase of CoGd contents due to anisotropic nature of Co. MCP shows the complex magnetic permeability to increase with CoGd concentration while the complex permittivity decreases.     

Changes in phytosterol contents during rape seed storage under conditions simulating industrial silos

During seed storage in tall silos the low layers of rape seeds are exposed to static pressure exerted by the upper layers. This may cause deformation and damage of seeds found in the lower layers and losses of biologically active compounds. The aim of this study was to simulate under laboratory conditions the actual ecosystem found in industrial plants and to evaluate the effect of not only the temperature and moisture content, but also static pressure on degradation of phytosterols contained in rape seeds in the course of storage. Changes in phytosterol levels were assessed using GC-MS. During storage in all samples of seeds (7–16% moisture content) under the adopted conditions of overpressure (20–60 kPa) and temperature (25–35 °C) the total content of phytosterols decreased by 3–57%. The smallest losses in the total phytosterol contents (3–4%) were recorded during storage of seeds with a 7% moisture content, irrespective of the applied storage temperature (25–35 °C) and overpressure variants (20–60 kPa). The greatest losses of phytosterols (43–57%) were observed during storage of seeds with a 16% moisture content at a temperature of 35 °C, while the higher the applied overpressure, the greater these losses were. The study showed that the greatest influence on sterol content during storage was increased seed moisture, and subsequently the temperature and the pressure. Experimental results also showed that for seeds with higher moisture contents (13 and 16%) an increase in storage temperature from 30 to 35 °C intensifies losses of individual phytosterols much more markedly that an increase in temperature from 25 to 30 °C. Moreover it was observed that overpressure over 20 kPa enhanced losses of investigated phytosterols.     

气藏采收率影响因素研究与启示——以靖边气田A井区为例

以鄂尔多斯盆地靖边气田A井区为例，采用单因素相关分析和数值模拟方法，对比研究了井网控制程度、储层物性及地层废弃压力对气藏采收率影响及其主次关系。结果表明，井网控制程度是影响采收率的首要因素，井网控制程度每增加10%，采收率提高8.5%；渗透率是影响采收率的重要因素，渗透率每增加10%，采收率平均增加6%；废弃压力对采收率亦有较大影响，废弃压力每降低10%，采收率可提高1.6%。三者对采收率影响综合排序为：井网控制程度>储层物性>废弃压力。分析认为，渗透率是储层固有属性，很难从根本改变；而废弃压力受井口外输压力和增压开采成本制约，降低幅度有限。因此，优化井网及增加井网控制程度是提高气藏采收率的有效途径。研究成果具有实践意义，可为改进气田开发方式和提高气藏采收率提供参考。     

Transient Simulation of Hollow‐Fiber Membrane Filtration with Nonuniform Permeability Distribution

Transient simulation of filtration in hollow‐fiber membranes with nonuniform permeability distribution was conducted. The diversity of permeability distributions caused different initial flux and transmembrane pressure distributions. Manipulating the permeability distribution enables a hollow‐fiber membrane to achieve its maximum volumetric flow rate. During solid‐liquid separation, the inter‐adjustment between flux and cake distributions improved their uniformities simultaneously. The reciprocal of the volumetric flow rate of the membranes all increased linearly with water production. Severely nonuniform permeability distribution caused low water production. The numerical results could be applicable to account for the non‐ideal performance of industrial hollow‐fiber membrane modules.     

Review on recent advances of zinc substituted cobalt ferrite nanoparticles: Synthesis characterization and diverse applications

Researchers have taken a prodigious consideration in characterizing and synthesizing zinc substituted cobalt ferrite nanoparticles because of their substantial applications across diverse technological and industrial fields. Zinc substituted cobalt ferrite nanoparticles are a class of lenient magnetic nanomaterials, which have potentially high magnetic, optical, electrical, and dielectric properties. These properties include a high value of permeability, low power losses, permittivity, saturation magnetization, coercivity, resistivity, and other beneficial properties that make them promise candidates for applications in various fields. These ferrites are also used in biomedical areas such as MRI and cancer treatments. In electronic fields, zinc substituted cobalt ferrite nanoparticles are used to make transducers, transformers, biosensors, and sensors. Apart from these advantages, they are found in our everyday electronic and electrical appliances like LED bulb, refrigerator, mobile charger, TV, microwave oven, juicer, washing machine, mixer, iron, printer, laptop, mobile, desktop, etc. Hence, the current review reports some properties of these spinel ferrites and emphasizes the different synthesis techniques that can be used to prepare them. Afterward, the impact of dopant on the materials' properties, the characterization techniques, and the momentous application in the present era have been well discussed.     

Experimental study on the permeability and self-healing capacity of geosynthetic clay liners in heavy metal solutions

Geosynthetic clay liners (GCLs), which have a very low permeability to water and a considerably high self-healing capacity, are widely used in liner systems of landfills. In this study, a series of experimental tests were carried out under complex conditions on typical commercial GCLs from China. In particular, the effects of pH values and lead ions (Pb²⁺) were tested in addition to other factors. The swelling properties of natural bentonite encapsulated between geotextile components in the GCLs were tested first. The swelling capacity was reduced rapidly at pH values < 3 and concentrations of Pb²⁺ >40 mM. Permeability tests on GCLs with different concentrations of lead ions were then performed by using the self-developed multi-link flexible wall permeameter, and data showed that increases in lead ion concentrations greatly improved the permeability. Finally, self-healing capacity tests were conducted on needle-punched GCLs under different levels of damage. Results showed that the GCLs have a good self-healing capacity with small diameter damage holes (2 mm, close to three times the original aperture), but with a damage aperture larger than 15% of the sample area, the self-healing capacity could not prevent leakage; hence, in certain situations it will be necessary to repair the damage to meet the anti-seepage requirement.     

Permeability differences based on three-dimensional geometrical information of void spaces

In this study,the permeabilities of Berea and Otway sandstones were measured under different confining pressures,and porosity was investigated through mercury intrusion porosimetry(MIP).The total porosities of the Berea and Otway sandstones were approximately 17.4%and 25%,respectively.Pore size distributions of each sandstone were almost the same,but the pores in the Otway sandstone were slightly narrower.However,the permeability of the Otway sandstone was smaller than that of the Berea sandstone by one order of magnitude.Three-dimensional(3D)void geometry and geometrical properties of the void spaces relevant to flow were compared to obtain the relation between the permeability differences and porosities of the two sandstones.The 3D geometrical analysis using microfocus X-ray computed tomography(CT)was performed,and the pore geometries of both sandstones were compared using the 3D medial axis(3DMA)method.Pore and throat radii,pore coordination number,tortuosity,number of connecting paths,connecting path volume,and other factors were determined using 3DMA.The Otway sandstone was characterized by a small effective throat/pore radius ratio.Based on the fluid flow mechanism,the lower effective throat/pore radius ratio results in a lower permeability induced by the fluid energy loss,which means that the 3D geometrical shape of void spaces affects the permeability value.     

流量替代渗透率评价破碎性储层工作流体伤害程度

若地层岩石整体强度偏低,在力学环境改变后岩石易破碎成不规则破裂体,则储存油气资源的此类破碎地层被称为破碎性储层。由于破碎性储层在纵向上存在着较强的非均质性,通过测试单个柱塞岩样在工作流体伤害前后的渗透率变化难以体现工作流体对储层的整体伤害程度。为此,利用达西定律先从理论上探讨用流量替代渗透率定量表征储层伤害程度的可行性,再开展单层开采、双层及三层并采的流量测试实验,评价工作流体对单层、多层储层的整体伤害程度,并将流量损害率与渗透率损害率进行对比以求证流量替代渗透率的可行性。研究结果表明:①单层开采时,流量损害率与渗透率损害率基本一致,渗透率损害率是流量损害率的一种特殊形式;②双层及三层并采时,单层各自稳定流量损害率与渗透率损害率接近,且流量损害率可以定量表征并采储层的整体伤害程度,而渗透率损害率则无法定量表证;③稳定流量损害率较累积流量损害率更接近渗透率损害率。结论认为,测定稳定流量可以替代测定渗透率评价工作流体对破碎性储层的伤害程度,从而为优选工程技术与评价工作流体的适应性提供了方法依据。